Wood · Edges
Edge banding calculator
Edge tape = for each part, the banded long edges × length + the banded short edges × width, times the quantity, plus an allowance per edge for the overhang the trimmer takes off. The example below, the doors, drawer fronts and carcass parts of a kitchen run, needs 30.20 m of edge, 32.24 m with 30 mm per edge.
—
Edge tape
— m
Net edge
— m
Banded edges
—
edges that get tape
Rolls
—
Cutting the parts too? The panel cutting optimizer lays them out on the fewest sheets, with the grain. With the banded edges already marked, by piece of furniture: wardrobe, kitchen cabinets or dresser.
Everything runs in your browser; your list is kept in this browser only.
How this is calculated
per part = qty × (long edges × length + short edges × width)
allowance = qty × (long edges + short edges) × allowance per edge
rolls = ⌈ total / roll length ⌉
What this page does not do
- One tape at a time. Different thicknesses or colours: run them as separate lists.
- No machine set-up waste. Add it to the allowance if your edgebander loses tape at the start of each run.
Questions people ask
- How do you calculate edge banding?
- For every part, multiply the length by the number of long edges banded and the width by the number of short edges banded, add them, multiply by the quantity, and add an allowance for each banded edge. The kitchen example on this page has 68 banded edges and 30.20 m of edge; with 30 mm per edge it is 32.24 m.
- How much extra edge banding should I allow?
- Enough for the tape to overhang both ends so the trimmer can cut it flush; a few centimetres per edge is common. Set your own figure: it is added once for every edge that is banded.